Magio MG-490, Instruction Manual

Page: 20 / 24

18
• Use the accessories recommended by the manufacturer only.
• The appliance must not be immersed in water.
• Protect the device from falls and hits.
• Check the condition of the mains plug and the power cord for damage
regularly.
• Do not repair or take apart the device by yourself. If any malfunctions
occur, as well as after the device has fallen, unplug it from the outlet and
contact the nearest (authorized) service center by the contact addresses
indicated in the warranty card or on the website www.magio.ua.
• To protect the environment, when the operating life of the oven came
to the end, do not dispose the device with household waste, but take it
to a designated collection point for recycling.
• Do not put the appliance in the dishwasher.
• Store the appliance in a cool dry place out of the reach of children and
people with disabilities.
• The device should only be transported in its original packaging.
• Do not switch on the appliance without water.
Before first use
After transportation or storing the device at a low temperature, keep it at
room temperature for three hours at least.
- Check the integrity of the appliance, if damaged, do not use the
appliance.
- Remove any stickers and packing materials that interfere with the
operation of the appliance.
1. Remove the kettle from the base (7).
2. Press the button for opening the lid (4).
3. Fill the kettle with water up to the «MAX» mark.
4. Close the lid (3) by pressing it until you hear a click.
5. Place the kettle on the base.
6. Connect the unit to the power outlet.
7. Set the on/off button (6) to position (I) by pressing it.
8. Wait for the water to boil and the kettle will automatically turn off.
9. Drain the water and repeat the above procedure two more times.
Make sure the kettle is switched off before removing it from the
base.
Do not fill the kettle below the «MIN» mark and above the «MAX»
mark.
Keep the appliance dry.
Do not open the lid while the water is boiling.