Magio MG-105, Instruction Manual

Page: 23 / 25

23
EN
Before first use
You can turn off the electric kettle by yourself by pressing the on / off
key (2), the key will go to the off position (O), the key backlight will go
out.
Note
Operation
Attention! You may turn the kettle on with water in it only. Before turning
the kettle on, make sure it’s full.
• The device should only be transported in its original packaging.
After transportation or storing the device at a low temperature, keep it at
room temperature for three hours at least.
1. Check the integrity of the device. If it is damaged, do not use it.
2. Remove all the stickers and packing materials that are obstructing the
device operation.
3. Wipe carefully the inside of the appliance with a wet cloth.
4. Unreel the power cord (8) and plug into an outlet.
5. To fill the kettle with water remove it from the stand (6), open the lid (1) by
pressing the lid opening button (7).
6. Fill the kettle with water till the MAX water level mark inside the kettle.
Close the lid, put the kettle on its stand (6).
7. Turn the kettle on by pressing ON/OFF button (2). The button will be
fixed in «on» position ( I ) and light up.
8. When the water has boiled, the kettle will switch off automatically. The
button will switch to the «off» position ( O ) and light off.
9. Pour the water out and repeat this procedure if needed.
1. P lug the electric kettle into the wall socket.
2. To fill the electric kettle, remove it from the stand (6), open the lid (2) by
pressing the lid opening button (7) and fill it with water paying attention
to the water level mark that must be not lower than the «MIN» mark and
not higher than the «MAX» mark. Close the lid tightly, place the electric
kettle on a stand (6).
3. Turn the kettle on by pressing ON/OFF button (2). The button will be
fixed in «on» position ( I ) and light up.
4. When the water has boiled, the kettle will switch off automatically. The
button will switch to the «off» position ( O ) and light off.
5. Before removing the kettle from the stand, make sure that it is turned off,
that the ON/OFF button is in «off» position ( O ), no lighting on.
6. After switching the kettle off wait for 15-30 seconds. Then you can start
boiling water again.