Page 38
3.9.3. Continuation of Installation - Trim Switch Control Model
1. Unpack the battery pack and connect to
the battery connection on the cable.
2. Fit the connectors on the cable to the
drive motor ensuring correct polarity.
The cable connectors must be matched
to the appropriately sized spade
connector.
3. Test the operation of the drive motor
using the trim switches (
2.1.4 - Lighting
Procedure (Optimum Control and
Trim Switch Control)
on page
9
).
4. Proceed
to
Section 3.9.5
to commission
the appliance.
4xAA
BATTERIES
Figure 48
3.9.4. Installation of the Glass (Physical) Barrier (if supplied)
1. At the desired position under the
appliance mark the positions for fixing
the two support brackets. Ensure that
the positions of the brackets are level
(see
Figure 49
).
2. Drill and plug at the marked positions.
(see
Figure 50
)
3. Undo the screw at the base of the
bracket, to gain access to the screw hole
at the rear (see
Figure 51
).
4. Fix the brackets to the wall using the
screws provided (see
Figure 52
).
5. Remove the backing paper and apply the
self adhesive rubber pads to the
underside of each of the top sections.
(see
Figure 53
).
6. Position the larger plastic pads on the
bottom sections of the brackets (see
Figure 53
).
7. Place the glass centrally into the
brackets and fix in position by tightening
the screws in the base of the brackets
(see
Figure 54
).
Combustible objects must
not
be placed on the barrier.
The barrier is
not
designed as a
load bearing item.
APPLIANCE
Figure 49
8 mm
8 mm
Figure 50
