22 MAGICFX
®
SMOKEBUBBLE BLASTER
—
User and Installation Manual
3.6
CONNECT POWER AND SETUP DMX
PowerCon TRUE1 female
POWER
5-pole female
DMX
POWER IN
POWER OUT
DMX IN
DMX OUT
1.
Connect a power cable with a Powercon TRUE1 Female connector to the
power input.
2.
Connect the other end of the power cable to a 220 – 240 Vac (50 Hz) power
source.
3.
Connect the female connector of a 5-pole DMX cable in the DMX input.
4.
Connect the other end of the DMX cable to your DMX controller.
5.
Switch the machine ON (If Manual mode is ON, the machine starts bubbling
instantly).
6.
Make sure that in the menu Manual mode is OFF, see Section 1.7.
7.
Use the display and buttons or a RDM controller to assign DMX addresses, see
Chapter 1.
8.
Optionally see Section 3.7 for adding more machines to the same sequence.
CAUTION
Always plug in a DMX Terminator into the DMX output. Using a
DMX Terminator improves signal reliability.
