Version 1.0
Page 14
The display will now show the screen
pictured on the left.
You will see the address behind Safety flash
on and off: this is the address for releasing
the machine.
Change to the required address by
pressing on the
▲ or ▼ button. Then
press the MODE button to confirm your
choice.
When using several machines it is
recommended
to use the same ‘Safety’
channel for each Shot Base DMX.
If you want to restore the addresses to
standard values then press on the LOCK
button for each address. The address will
then return to the standard value.
8.
-Of-
Press the ‘MODE’ button to start the Shot
Base DMX set-up.
The Shot Base DMX now gives you two
set-up choices.
Set addresses by sequence
You only set the Safety address and the first
output address through which the other 3
output addresses are automatically set in
numerical order.
Set addresses individually
You set all 5 addresses separately.
Change to the required mode by pressing
the
▲ or ▼ button. Then press the MODE
button to confirm your choice.
7.
Before you start to load the Shot Base
DMX with the cannons you must install
the Shot Base DMX correctly.
During installation, make sure that you use
free channels on the DMX controller and that
these channels are in the safe mode. The
safe mode means that during the installation
of the Shot Base DMX the 0-values of a
channel are set. Consult the manual of the
DMX controller for the set-up.
6.
Summary of Contents for SHOT BASE DMX
Page 1: ......
Page 2: ...PRODUCT CODE MFX0350 VERSION 1 0 DATE 26 02 2013...