In Range Display Method
If the remote and vehicl e are within operating range of each other, the signal
strength will be displayed beside the antenna icon on the display.
32
In Range Display
Battery Save Function
Set-up and Other Functions
When the battery is al most dead and ready to be replaced, t he battery icon wil l flash
and Battery Save Mode wi ll operate.
Flashes 5 times
Battery Save Mode Operation
The remote will only receive confirmation signals for button I operat ions.
The other butt ons will still function, but they wil l not receive confirmati on signal s
back from the vehicle.
The transmitting power will be reduced for a close range operation only.
Flashes 5 times
Knocking (For door open or entering the password.)
31
The password should be entered under t he,
“
car condit ions for entering a password
”
(see page 28).
Knock on the RPS sensor 10 ti mes
Knock as many times as the first password number, and then check to see if
the red LED flashes.(Knock as many times as t he first password number)
After the first set
The second, third, and fourt h password numbers should be entered the same as
a b o v e .
(As the password has four numbers.)
After ent eri ng the final set
The parking light s will flash, signaling that the password has been entered.
Unlocki ng the doors usi ng the RPS
To unlock the doors using the RPS, t he code must be entered correctly, matching
the code you specified initial ly. The remote will be paged and will show that the
doors have been unlocked.
The Green LED will flash at the first knock.
After 1.5 sec
The next knock shall be done within 1.5 sec.
Red LE D flashes a s many time s as the
number of the f ir st set of knocks.
Red LED flashes fast
Green LED will flash at the first knock.
