MAGIC FX MFX0803, User And Installation Manual

Page: 21 / 36

MAGICFX® STADIUMBLASTER — User and Installation Manual 21
3.5 BLAST WITH 24 V CONTROL
1.
Make sure that the prescribed safety zone is free from persons and objects.
2.
When it’s time to blast, continuously, enable the output on your 24 V controller and make
sure to produce a continuous pulse.
3.
Enjoy the view!
4. When the hopper is out of confetti, disable the output on your 24 V controller..
3.6 CONNECT POWER AND SETUP DMX
PowerCon TRUE1 female
POWER
5-pole female
DMX
1. Connect a power cable with a Powercon TRUE1 Female connector to the power input.
2. Connect the other end of the power cable to a 100-250 Vac (50-60Hz) power source.
3.
Connect the female connector of a 5-pole DMX cable in the DMX input.
4. Connect the other end of the DMX cable to your DMX controller.
5. Use the display and buttons or a RDM controller to assign DMX addresses, see chapter 1.
CAUTION
Always plug in a DMX Terminator into the DMX output. Using a DMX Terminator
improves signal reliability.