-37-
8
Optional accessories
Cross fence (cutting width fence)
Ref. No. 203 353
CT saw blade wrapped 160 x 1.8 x 20 mm, 16 teeth
Ref. No. 092 539
CT saw blade wrapped 160 x 1.8 x 20 mm, 24 teeth
Ref. No. 092 533
CT saw blade wrapped 160 x 1.8 x 20 mm, 32 teeth
Ref. No. 092 552
CT saw blade wrapped 160 x 1.8 x 20 mm, 56 teeth
Ref. No. 092 553
Saw assembly stops while cutting is in
process
Mains failure
Selected speed of forward momentum
too high
Check mains back-up fuse
Reduce speed of forward momentum
Saw blade jams as saw assembly is
advancing
Selected speed of forward momentum
too high
Blunt saw blade or saw blade not
suitable for the material
Tension in the workpiece
Reduce speed of forward momentum
Immediately stop forward momentum
by releasing the key and stop
machine. Remove saw assembly from
the workpiece and replace the saw
blade
Riving knife / splitter not available, in
contradiction to regulations. Stop
system as described above and
under
any circumstances
use riving knife /
splitter
Burn marks on kerfs
The saw blade used is unsuitable for
the task or blunt
Speed of forward momentum not high
enough
Replace saw blade
Increase speed of forward momentum
Chip ejection blocked
Wood is too damp
Cutting without chip / dust extraction
External chip / dust extraction too
weak
Use external chip / dust extraction, e.g.
portable dust extractor
Use stronger external chip / dust
extractor
Defect
Cause
Elimination
Before switching on again,
remove connecting hose
between chip outlet, saw
assembly and chip canal and
clean it
