![background image](http://html.mh-extra.com/html/mafell/k55cc/k55cc_operating-safety-instructions-manual_689046027.webp)
K55cc/KSS50cc
01/2022
27
Use the following procedure to adjust the
cutting width:
1.
Loosen the wing screws (5) on both sides.
2.
Adjust the roller edge guide.
3.
Tighten the wing screws (5) on both sides.
✓
The cutting width is adjusted.
Fig. 23: Adjusting the cutting width via the roller edge
guide
6
Service and maintenance
MAFELL machines are of a low-maintenance design.
The installed ball bearings are lubricated for life. After a longer period of operation, MAFELL recommends that
the machine be handed over to an authorized MAFELL service workshop for inspection.
6.1
Storage
Clean the machine thoroughly if you will not use it for quite some time. Spray bare metal parts with a rust
inhibitor.
7
Troubleshooting
Warning
Risk of injury from a sudden start of the machine.
There is a risk that the machine starts suddenly due to carelessness when
working with the machine or during troubleshooting. The rotating saw blade can
cause serious injuries.
➢
Determining the causes of existing malfunctions and their elimination
always require increased attention and caution!
➢
Pull out the mains plug before you start troubleshooting!
Some of the most common malfunctions and their causes are listed below. For other malfunctions, please
contact your dealer or MAFELL Customer Service directly.
Malfunction
Cause
Elimination
Machine can not be switched on
Mains voltage missing or too low
Have the power supply checked
by an electrician
Mains fuse defective
Have fuse replaced by an
electrician
Carbon brushes worn out
Take the machine to the MAFELL
customer service workshop