-14-
2.4 Scope of supply
Drilling station BST 650 S, BST 460 S, BST 460 or BST 320 complete with:
1 insert panel
1 service tool in bracket on the machine
1 operating manual
1 folder “Safety Instructions”
2.5 Use according to intended purpose
The drilling station is an all-purpose unit for drilling
into wood and wood-like materials. It is used along
with a suitable drill with a collar of Ø 43 mm.
e.g. MAFELL Type HSB
Any other use than described above is not
permissible. The manufacturer cannot be held liable
for any damage arising from such other use.
In order to use the appliance as intended, you must
comply with the operating, maintenance and repair
instructions specified by MAFELL.
2.6 Residual risks
Danger
Even if used in accordance with its
intended purpose and despite
conforming with the safety
instructions, residual risks caused
by the intended use will always
remain.
-
Touching the drill bit while drilling
-
Drill bit breaks
-
Hearing impairment due to working without ear
protection for longer periods of time
-
Emission of hazardous wood dust when operated
in closed areas with insufficient ventilation for
longer periods of time.
3 Safety instructions
Danger
Always observe the following safety
instructions and the safety
regulations applicable in the
respective country of use!
General instructions:
-
Never work without the protection devices
prescribed for the respective operating sequence
and do not make any changes to the device that
could impair safety.
-
Children and adolescents may not operate this
device. This rule does not apply to young persons
receiving training and being supervised by an
expert.
-
Consider environmental influences. Do not expose
the device to rain and avoid working near
combustible liquids or gases.
-
Chips or slivers must not be removed while the
machine is in operation.
-
Store the device in a dry, locked place outside the
reach of children.
Instructions on the use of personal protective
equipment:
-
Always wear ear protectors during work.
-
Always wear protective goggles during work.
-
Always where a dust mark during work.
Instructions on operation:
-
Provide for an unobstructed and slip-proof location
with adequate lighting.
-
Check to ensure that the tool is clamped correctly
before switching it on.
-
As far as possible ensure that the workpiece is
secured from slipping away and toppling by using
e.g. tension clamps.
-
Ensure that the area where the drill bit emerges
from the workpiece is free of obstacles.
-
Examine the workpiece for foreign objects.
-
Never reach under the workpiece while working
(risk of injury!).
Summary of Contents for BST 650S
Page 2: ......
