-7-
If you find it necessary to remove a factory installed drain pump, it is very important to follow all the
instructions below. Please refer to our website at ContinuumFootspas.com and refer to diagram,
“Plumbing Rough-In” and carefully follow
all
the following instructions:
Step 1
Disconnect power to the Maestro Pedicure Spa.
Step 2
Locate the black curved plastic shroud beneath the wood base. Remove the right side panel only. (as
you face the pedicure spa)
EXTREMELY IMPORTANT:
Locate the fuse plate and remove the fuse
marked: “Drain Pump.” Discard fuse and replace the black plastic fuse holder cap.
Step 3
Locate yellow hanging tag marked “DRAIN PUMP DISCONNECT.” This tag is located near the power
supply box.
UNLOCK THE QUICK DISCONNECT FITTING NEXT TO THE HANGING TAG. LEAVE
ALL OTHER QUICK DISCONNECT FITTINGS IN PLACE.
Step 4
Utilizing a phillips head screwdriver, carefully remove the black side panel located on the left side
beneath the basin. This will expose the drain pump.
Step 5
Carefully disassemble and remove plumbing fittings associated with the drain pump. Fittings that need
to remain in order to connect a P-Trap should not be removed. Carefully remove drain pump together
with attached yellow jacketed wire cable. Discard drain pump and attached wire cable as they are no
longer needed.
Step 6
Proceed to plumb drain (with P-Trap, not supplied) to comply with all national, state and local plumbing
codes and/or regulations.
After all plumbing connections are completed, replace all cover panels and secure in place.
MAESTRO
®
PEDICURE SPA
