-12-
Technician’s Control Keypad (12)
EXTREMELY IMPORTANT
Never, under any circumstances, should one spray water directly on the Technician’s Control
Keypad. This will damage the Control Keypad and void the limited warranty.
FILL MODE
IMPORTANT NOTE:
In order to activate water flow, the Temperature Control Handle (14) MUST remain in any position except
vertical.
To add water to your spa simply press the “Fill” button. The basin will start filling with water. Place your
hand in the basin to test the water temperature for comfort and safety. Adjust water temperature utiliz-
ing temperature control handle (14) as needed. Once desired water temperature is set, close the drain
by turning drain handle (13) counter-clockwise.
The Maestro Pedicure Spa is equipped with a water level sensor located near one of the jets. When the
water level reaches the fill sensor, water continues to run for two (2) seconds and then shuts off auto-
matically.
The fill cycle is timed out at two (2) minutes and 15 seconds. Provided water pressure is adequate, the
fill sensor will shut off water flow at the correct level well before two (2) minutes and 15 seconds.
If additional water is desired, simply
press and hold
the “Fill” button.
MAESTRO
®
PEDICURE SPA
