STEP 1
– Remove the two handlebar clamp bolts ON ONE SIDE ONLY and
DO NOT remove the top clamps, only the bolts. (If you remove all four
handlebar clamp bolts or your bars will come loose!)
STEP 2
– Set two of the aluminum spacers provided in your kit into the two
holes in the now-open top clamp, as seen in the photo above. Put one M8 flat
washer on top of each spacer. To keep it from slipping off, put a dab of Vaseline
or similar thick grease on top of the
spacer so that the flat washer will
stick to it and not slide off.
Or, pre-assemble the new long
bolts with washers right onto the
MadStad bracket as shown at right.
Just hold the bolts and washers in
place so they don’t fall out when
you go to set them into the spacers
and lower bar clamp.
