Bracket Installation:
STEP 1
– Remove two of your
handlebar clamp bolts ON ONE
SIDE ONLY. (If you remove all
four handlebar clamp bolts your
bars will come loose, and we don’t
want to do that.)
Remove the bolts but leave the top
clamp in place. The MadStad
brackets will bolt on top.
STEP 2
– Set two of the aluminum spacers provided in your kit into the two
holes in the now-open top clamp, as seen in the photo above. Put one M8 flat
washer on top of each spacer. To keep it from slipping off, put a dab of Vaseline
or similar thick grease on top of the
spacer so that the flat washer will
stick to it and not slide off.
Or, pre-assemble the new long
bolts with washers right onto the
MadStad bracket as shown at right.
Just hold the bolts and washers in
place so they don’t fall out when
you go to set them into the spacers
and lower bar clamp.
