MADRIX Nebula, Technical Manual & Quick Start Manual

Page: 14 / 36

13
EN
3) Device Configuration
Step 1) Connect MADRIX
®
NEBULA and your computer to the same network.
Step 2) Assign correct network settings in the computer's operating system.
(Recommended: IP address 10.0.0.1 / Subnet mask 255.0.0.0)
Step 3) Open your web browser and enter the IP address of MADRIX
®
NEBULA.
(You can find the default IP address on the side of the NEBULA device.)
Step 4) The built-in web configuration tool will be launched. Go to 'SPI Output
Configuration' > 'Output Protocol' and choose the LEDs your are
using for 'Port 1' and 'Port 2'. You can choose the output protocol
separately for each of the two ports. Apply changes with 'Set'.
Step 5) Change any other settings as required. Apply changes with 'Set'.
Basic Configuration Using The
MADRIX
®
HARDWARE MANAGER Software
Step 1) Connect devices to your computer over USB or network, but not both!
Step 2) Make sure to stop sending control data to the devices!
Step 3) Start the MADRIX
® HARDWARE MANAGER Software.
Step 4) In MADRIX ® HARDWARE MANAGER, go to the tab 'Devices' and
confirm or change the network settings and any other settings for your
devices as required.
On a selected device, use Right Mouse Click > 'Open Device
Configuration Via HTTP...' to open the web configuration through a
web browser, as explained above.
On a selected device, use Right Mouse Click > 'Restore Factory
Default Settings' to perform a reset to factory default settings.
For more information, see the MADRIX ® HARDWARE MANAGER User Manual.
The software is available for download from www.madrix.com
Please note: In order to put MADRIX ® NEBULA fully into operation, set the
correct output protocol according to the LEDs you have connected.