26
Naming Your Inputs
To give an input a new name:
1
SELECT THE INPUT YOU WISH TO RENAME
Note that the input to be renamed needs to be selected prior to naming.
2
PRESS AND HOLD THE MODE BUTTON
After a delay of approximately five seconds, the display will change to
SET
NAME
), as shown below.
When you see this message in the display, you can release the
mode
but-
ton, at which time the display will show the current name of the selected
input.
3
PRESS THE SELECTED INPUT’S BUTTON REPEATEDLY UNTIL YOU SEE THE
NAME YOU WISH TO USE
This action will cause the display to cycle through the list of available
names, with the input number appended to the end of each name. For ex-
ample, you might wish to change input #6 from
NOT USED
to
LD6
if the digi-
tal output of your laserdisc player is plugged into the EIAJ input. In this
case the display would appear initially as follows:
and you would cycle through the various names until you saw: