Find desired location as high up floor board
as possible. Mark locations of bolt holes
with a marking pen.
Caution: Before drilling into floor board be sure there are no obstructions on opposite side
Using a 1/4” Drill bit for the bolt holes
drill through floor board. Using the
measurements given, drill a 1/2’’ hole
in the floor for the fan harness. Feed
harness through hole.
1/2” Harness Hole
Back side
Attach fan to floor using four 6mm x 45mm
hex head bolts as shown. Use rubber side of
washer at fan bracket and underneath cart
to seal hole. Once all 4 bolts are in place,
tighten hardware. Route harness under cart
to battery compartment and secure to frame
using supplied zip ties. See STEP 9 for In-
Line fuse instructions.
NOTE:
DO NOT overtighten hardware as
this can cause damage to brackets and floor.
1
1/2’’
7
1/4’’
