Trim off excess bolt by marking
threads. Remove and cut one bolt at
a time using a hacksaw.
Secure harness to strut using supplied
mounting ties or run harness inside
strut. For a cleaner look drill a hole
at the top of strut and feed harness
inside and out the bottom.
For floor mounted fans, attach
mounting brackets to fan by firmly
pushing brackets until they click on
fan tabs as shown.
(A) Attach supplied male spade connector
to red (+) wire and the 5/16” ring terminal
to black (-) wire.
(B) Plug in line fuse assembly to red (+)
wire and attach to 12 volts.
NOTE:
Voltage reducer from light kit
instructions.
NOTE: The fan will mount to the TXT, and Star cart floor. Madjax does not recommend
a floor mounted fan location on the Club Car, *E-Z-GO
®
RXV
®
, and YAMAHA
®
vehicles
due to space limitations.
If vehicle has 8 volt battery configuration a voltage
reducer must be correctly installed. Madjax
recommends using the 36/48-Volt Power Converter,
MJ1230C or 16-12 Volt Reducer, MJ1612VR.
Additionally, the Madjax Voltage Reducer Harness,
13-017 is recommended when using the 16-12 Volt
Reducer.
