©Copyright LOTRONIC 2017
MAD-RT200SP
3
RCA Audio Out
Play back your turntable music through external speakers. To make this connection, you need an RCA cable.
Play 45rpm Vinyl
Place the 45 rpm ADAPTOR over the spindle. Gently place your 45rpm record onto the turntable. Follow the steps
under Turntable operation to play your record.
Replacing the Stylus Cartridge
Refer to figures 1-8
1.
Push the arm lock to release the tone arm.
2.
Take off the cap of the cartridge to access the needle.
3.
Separate slightly the cartridge from the socket.
4.
Unplug the audio wire from the cartridge.
To fit a new cartridge, repeat process 3 & 4 in reverse order.
Note: Please be extremely careful whilst performing this operation so as to avoid damaging the tone arm and audio
line wires. The Turntable’s cartridge needs to be replaced every 3 – 4 months after continuous playing. Replacement
Ceramic type Cartridges are widely available to purchase from the internet
.
Troubleshooting
1.
The unit can’t be switched on.
Make sure that the turntable is connected to the power and check that you turn on the PWR/VOL. Button.
2.
Unusual noise from the speaker?
Check if your vinyl track is damaged. Also make sure your stylus needle does not need to be replaced. (Please replace
every 3-4 months based on continuous usage).
Don’t turn the recorder’s speaker volume to the MAX level to avoid Distortion.
Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local authorities or your dealer about the way
to proceed.
