Madill 1200, User Manual

Page: 6 / 45

MADILL 1200
- Electrical wires, battery cables, hydraulic hoses and fuel lines must be inspected daily
and replaced immediately if damaged or worn.
- The radiator and engine cooling system should be cleaned and serviced daily to
maintain moderate engine temperatures.
- Ensure a fire extinguisher and other required fire fighting equipment are on the machine
and properly maintained.
- When welding on the machine, ensure that the area to be welded has been thoroughly
cleaned of any flammable materials and that a fire extinguisher is within close reach.
- Refuel the machine only after the engine has been stopped and allowed to cool down.
For machines with an automatic fire suppression system the following
precautions are required to ensure maximum effectiveness:
- The house must be kept down with all access doors closed while the machine is
running except when required for service, maintenance and inspections.
- If a fire is detected before the system has discharged, activate the system manually.
DO NOT wait for the system to automatically activate.
REPLACEMENT OF LEXAN AND MARGUARD WINDOWS
It is important that damaged Lexan or Marguard windows be replaced with the equivalent
product. Substitution with an inferior product may greatly reduce the level of protection to
the operator and WCB requirements may not be met. For example, the impact strength
of Lexan is 200 times that of glass and 30 times that of acrylic.
PROTECT THE OPERATOR - DO NOT SUBSTITUTE AN INFERIOR PRODUCT!
LEXAN & MARGUARD WINDOWS - CLEANING INSTRUCTIONS
When Lexan sheet is first installed, glazing compound and masking paper adhesive can
be easily removed by applying naphtha (VM&P) or kerosene with a soft cloth, followed
immediately with a thorough soap and water cleaning. DO NOT USE GASOLINE!
Adherence to regular and proper cleaning procedures is recommended to preserve
appearance.
WASHING TO MINIMIZE SCRATCHING
Wash LEXAN XL sheet and LEXAN THERMOCLEAR sheet with a mild soap or deter-
gent (e.g. JOY Dishwashing Liquid) and lukewarm water, using a clean sponge or a soft
cloth. Rinse well with clean water. Dry thoroughly with a chamois or moist cellulose
sponge to prevent water spots. Do not scrub or use brushes on these products; their
coating is UV-resistant, not mar-resistant. Fresh paint splashes, grease and smeared
glazing compounds can be removed easily before drying by rubbing lightly with a good
grade of VM&P naphtha or isopropyl alcohol. Afterward, a warm final wash should be
made, using a mild soap or detergent solution and ending with a thorough rinsing with
clean water.
Section One Page 2c