OPERATION OF THE MACHINE
-
Be sure to carefully read and follow safety
instructions.
-
Keep hands away from blades. Never grasp the
exposed cutting blade or cutting edges
，
when
picking up or holding the tool.
-
Never touch the cutting device when starting the
engine and during operation.
-
Operate the Hedge Trimmer in such a manner as
to avoid inhalation of the exhaust gases. Never
run the engine in enclosed rooms (Risk of gas
poisoning). Carbon monoxide is an odorless gas.
-
All protective installations and guards, supplied
with the machine must be used during
operation.
-
Never operate the engine with a faulty exhaust
muffler or if it is missing.
-
Use the Hedge Trimmer only in good light and
visibility. Always ensure a safe footing.
-
Never stand on a ladder and run the Hedge
Trimmer. Keep both feet on the ground.
-
Never climb up the trees with the Hedge
Trimmer to perform cutting operation.
-
Never work on unstable surfaces.
-
Remove sand, stone, nails, wire, etc. found
within the working area. Foreign objects may
damage the cutting blades.
-
Before commencing cutting, the cutting blades
must have reached full working speed.
-
Always hold the Hedge Trimmer firmly with both
hands one handles only.
-
The right hand grip with thumbs and fingers
encircling the handles.
-
When you release the throttle
，
it takes a few
moments before the cutting blades stop.
-
The Hedge Trimmer must not be used for cutting
with fast idle. The cutting speed cannot be
adjusted with the throttle control in fast idle position.
-
When cutting a hedge
，
the machine should be held so that the blades from a 15-
30’ angle with the cutting line.
-
If the Hedge Trimmer is used with circular movements against the edge of the
hedge, the Hedge Trimmer is used with circular pendulation, swinging up and
down close to the hedge.
-
Pay special attention when cutting hedges which are laid out a long a wire-fence
