MADER LJ1500-24, Manual

Page: 30 / 41

6
compressor is used.
1.
Pull ring on safety valve and allow it to snap
back to normal position.
▲ WARNING!
Safety valve must be
replaced if it cannot be actuated or it leaks air
after ring is released.
2.
Turn compressor off and release pressure
from system. Drain moisture from tank by
opening drain cock underneath tank.
3.
Clean dust and dirt from motor, tank, and
airlines and pump cooling fins while
compressor is still OFF.
IMPORTANT:
Locate unit as far from spraying
area, as hose will allow preventing overspray
from clogging filter.
LUBRICATION
This is an oil less type compressor requiring no
lubrication.
THERMAL OVERLOAD PROTECTOR
▲ CAUTION!
This compressor is
equipped with an automatic reset thermal
overload protector, which will shut off motor if it
becomes overheated.
If thermal overload protector shuts motor OFF
frequently, look for the following causes.
1.
Low voltage.
2.
Clogged air filter.
3.
Lack of proper ventilation.
▲ CAUTION!
If the thermal overload
protector is actuated, the motor must be allowed
to cool down before start-up is possible. The
motor will automatically restart without warning
if left plugged into electrical outlet and unit is
turned on.
STORAGE
1.
When not in use, store hose and compressor
in a cool dry place.
2.
Drain tank of moisture.
3.
Disconnect hose and hang open ends down to
allow any moisture to drain.
TECHNICAL DATA
MODEL LJ1500-24 LJ1500—50 LJ15002-50
Power 1.5Kw / 2Hp 1.5Kw / 2Hp 3Kw / 4Hp
Speed 2850 r.p.m. 2850 r.p.m. 2850 r.p.m.
Air Capacity 264 L/min 264 L/min 528 L/min
Pressure 8Bar / 116PSI 8Bar / 116PSI 8Bar / 116PSI
Voltage 230V~50Hz 230V~50Hz 230V~50Hz
Support Wheels Wheels Wheels
Oil No No No
Noise Level 97dB 97dB 97dB