MADER CARDEN TOOLS LSE2204, Manual

Page: 56 / 76

STEP 3: Attach Engine and the Oil Pipe
1. Attach the engine (#11) to the engine mounting plate using polyurethane block (#12) and large flat
washer Ø10 (#58), hex bolt M8x65 (#36), flat washer Ø8 (#37), lock washer Ø8 (#57), hex lock
nut M8 (#38).
2. Attach the clear oil pipe (#43) to the gear pump oil inlet connector, positioning by clamp (#44).
STEP 4: Attach Beam to the Tow Bar
1. Attach the beam to the tow bar using Hitch Pin (#50) and R Pin (#71), then tighten with hex bolt
M12x85 (#46) and hex lock nut M12 (#25).
2. Attach the oil inlet hydraulic hose (#39) to the gear pump oil outlet connector, sealing with O ring
Ø11x2.5 (#32).
3. Attach the oil return hydraulic hose (#42) to hydraulic reservoir connector, sealing with O ring
Ø14x2.5 (#33).
4. Remove hinge pin Ø5x26 (#83), cotter pin Ø2x10 (#84), screw M8x16 (#81) and lock washer Ø8
(#57) from control valve. Then connect the connecting plate to the control valve by reinstalling
items 83, 84, 57 and 81.
Note: Tighten hydraulic hose connector between torque of 80-90N·m. Adjust the hydraulic hose
to a non-kinked state and the connector should be upright.