Maclaren Ryder, Manual

Page: 11 / 15

3
EN
Instructions
IMPORTANT: • READ THESE INSTRUCTIONS CAREFULLY BEFORE USE AND KEEP THEM FOR FUTURE REFERENCE.
• APPLY BOTH BRAKES WHEN PARKING THE STROLLER.
• YOUR CHILDREN’S SAFETY MAY BE AFFECTED IF YOU DO NOT FOLLOW THESE INSTRUCTIONS.
1 TO OPEN THE STROLLER
A Release storage clip.
B Open out the stroller.
C Using foot, push the footplate down fully to engage the primary lock.
CAUTION: Ensure that all locking devices are engaged before use.
2 TO OPERATE BRAKES
A TO ENGAGE BRAKES: With foot, pull the brake levers fully back.
B TO RELEASE BRAKES: Push the brake levers fully forward.
CAUTION: Parking device shall be engaged during the loading and unloading of
children.
CAUTION: Ensure parking device is engaged before leaving the buggy
unattended.
3 TO OPERATE FRONT WHEEL SWIVEL LOCKS
A TO LOCK SWIVELS: Lift BOTH swivel locking levers.
B TO UNLOCK SWIVELS: Push down BOTH swivel locking levers.
4 SEAT BELT/SHOULDER HARNESS OPERATION
WARNING:
Avoid serious
injury from falling or sliding out. Always
use the crotch strap in combination with
the waist belt and shoulder straps.
TO FIT HARNESS:
A Pull shoulder straps over the childs shoulder then attach to the waist
clips by sliding strap loops onto the hooks.
B Insert both waist clips into the clasp, shoulder straps are secured once
the clips are fastened.
C Adjust strap lengths by sliding buckles. Belt and harness should be snug.
TO RELEASE HARNESS:
D Press the button on both the front and back of the clasp simultaneously
to release.
5 TO FIT HARNESS PADS( If Supplied)
A Lay open pad under shoulder harness strap.
B Fold pad over and secure Velcro strips.
6 TO OPERATE THE LEGREST
TO EXTEND THE LEGREST: Pull out both legrest sliders.
Reverse this process to retract legrest.
7 TO ADJUST SEAT RECLINE
A TO RECLINE SEAT BACK: Lift both hand grips to release seat locks and
slide the seat back to desired position. Lower hand grips to engage locks
on both sides.
B TO RAISE SEAT BACK: From rear of stroller push seat back to original
upright or desired intermediate position.
8 TO ATTACH THE HOOD
CAUTION: Overloading may cause a hazardous unstable condition to exist.
Maximum total capacity of hood pockets - 1.1lb (0.5 kg).
A With stroller open clip the hood to the handle tubes just above the
retaining blocks. Place rear apron behind seat back.
B Extend hood and press down on side hinges to lock open.
C The hood is removed by firmly pressing down the clip release tabs.
9 TO FIT THE RAIN APRON
A Place the apron over the hood front.
B Attach two eyelets (one each side) to the hood clips.
C Attach the two eyelets (one each side) to the front legs.
10 TO FIT THE SHOPPING BAG
CAUTION:
Overloading may cause a hazardous unstable condition to exist.
Maximum load 4.4lb (2kg) evenly distributed. The stroller may be folded with the
bag still attached but all contents must be removed. Failure to do this could
damage stroller and contents of shopping bag.
A Place bag on the ‘X’ frame under seat with lowest edge of bag at front.
B Attach front straps to front legs just below seat.
C Attach rear straps to rear legs just above horizontal tie bar.
11 TO FOLD THE STROLLER
Ensure the seat back is in its fullest upright position and the hood(if fitted) is
folded back. Remove contents of shopping bag. It is recommended that the
harness is fastened before folding the stroller.
A Using foot, lift up on footplate to release primary lock.
B Push down on secondary lock lever.
C Grip handles and push forward.
D Compress folded stroller and engage the storage clip.
12 REMOVING AND REFITTING THE SEAT COVER
Remove hood from stroller if fitted.
A Twist shoulder strap end buckles and feed through holes.
B The waist harness back strap is fixed to the chassis behind the seat.
To remove, twist the buckles on each end of the harness back strap and
unthread from the ‘D rings attached to the chassis.
IMORTANT
– It is important that the strap be rethreaded through the ‘D’
rings after the seat has been refitted. Failure to do so will endanger your
child.
C Feed crotch strap buckle through holes.
D Unclip seat cover retaining straps.
E Unfasten seat fabric from handle tubes and seat base.
F Slide fabric from seat back and base.
G When refitting seat fabric, insert seat back support tubes into fabric flap.
H When refitting shoulder straps, choose the fabric holes appropriate to
the child’s size. Twist the buckles and feed through seat cover, seat back
and then through holes in plastic seat back arms.
J When refitting seat fabric to seat base, choose the fabric holes
appropriate to the child’s size. Loop fabric flap over legrest strap and
pass crotch strap buckle through both holes in seat fabric and then hole
in seat base.