8
SDR24/96
SDR
24/
96
I/O Connections and Cables
I/O connections are available in either analog or digital and can be used in any
combination:
Analog
• Each 25-pin D-subminiature (DB25) connector provides eight balanced
analog line-level inputs or outputs. These connectors are pin-for-pin
compatible with the analog (not TDIF) DB25 connectors found on the
TASCAM DTRS recorders (see Appendix D: Analog I/O Pinout). DB25
cables that break out to XLR or 1/4" TRS connectors for mating with your
console are readily available (see Appendix E: Compatible Cables).
Digital
• The digital outputs are ADAT optical connections, and provide eight digital
inputs or outputs per connector (four if using 96 kHz sample rate).
Note: Different manufacturers use different wiring standards for DB25 in-
terface cables that otherwise look the same. Make sure the cable you are
using is the correct one.
See Appendix E for a list of compatible SDR24/96 Analog I/O cables.
Word Clock and Digital Synchronization
Various methods are provided to synchronize the SDR24/96’s sample clock and
time/transport position to other equipment. The functions and connections for
each of the sync connections are as follows:
•
SMPTE IN
— This 1/4" jack serves as an input when slaved to incoming
SMPTE time code. Use a shielded 2-conductor cable with a 1/4" TS plug.
•
SMPTE OUT
— This 1/4" jack serves as an output when generating
SMPTE time code to synchronize other devices with the SDR24/96. Use a
shielded 2-conductor cable with a 1/4" TS plug.
•
WORD CLOCK IN
— This BNC jack receives word clock from another
device when the SDR24/96 Sample Clock is set to Word Clock. Use this
input when the SDR24/96 is operating as a word clock slave. Use 75-ohm
coaxial cable with a BNC connector.
•
WORD CLOCK OUT
— This BNC jack transmits word clock to other
devices in the system when the SDR24/96 is configured as the clock
master (Sample Clock set to Internal). Use 75-ohm coaxial cable with a
BNC connector.
OUT
IN
IN
IN
OUT
OUT
DIGITAL
WORD CLOCK I/O
MIDI
ADAT SYNC
IN
ADAT SYNC
OUT
SERIAL
9-PIN
FOOT
SWITCH
SMPTE
MICRO/
REMOTE 24
CNTRL
RISK OF ELECTRIC SHOCK
DO NOT OPEN
REPLACE WITH THE SAME TYPE FUSE AND RATING.
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE
UTILISE UN FUSIBLE DE RECHANGE DE MÊME TYPE.
DEBRANCHER AVANT DE REMPLACER LE FUSIBLE
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. DO NOT REMOVE COVER.
NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.
CAUTION
SERIAL NUMBER
MANUFACTURING DATE
AVIS:
RISQUE DE CHOC ELECTRIQUE — NE PAS OUVRIR
, DESIGNED, AND MANUFACTURED BY MACKIE DESIGNS INC • WOODINVILLE • WA 98072 • USA
FABRIQUE AU USA • PATENTS PENDING COPYRIGHT ©1998 THE FOLLOWING ARE TRADEMARKS OR
ARKS OF MACKIE DESIGNS INC.: "MACKIE.", MACKIE DIGITAL SYSTEMS AND THE "RUNNING MAN" FIGURE.
1 - 8
IN
OUT
DIGITAL
9 - 16
IN
OUT
DIGITAL
17 - 24
X2
1-4
X2
5-8
X2
9-12
IN
OUT
