20
3. OPERATION
3.1 Recording - Local
Local recording is achieved through the LED’s and buttons
located on the top of the MacFi-mp unit. Please reference the
Manual Button & LED Configuration section of this manual for
additional information on functions.
Step 1 – Make all desired power, audio in, audio out,
configuration switch and I/O connections to the unit
and power up. Unit will initiate self test and default to
idle mode(approx. 2 seconds).
Step 2 – Depress Record Setup button, Record LED will blink
Step 3 – Use Select button to determine message location to
record to. Message Number Display shows the
selected message, both decimals blink when the
location is occupied.
Step 4 – Listen to record source through the audio output
and/or reference Sense and Overdrive LED's to verify
level.
Step 5 – Depress Start/Stop button to begin recording and start
audio source. Message and Record LED’s will remain
solid during recording.
Step 6 – Depress Start/Stop button to end recording and exit.
NOTE: Record Setup will time out after 1 minute
of inactivity.
3.2 Recording - Remote Control
Remote Control recording is achieved through the I/O
connections located on the endplate of the MacFi-mp unit. This
process is only applicable to the first eight (1 - 8) messages on
the system. Please reference the Hardware Configuration
section of this manual for additional information on available
connections.
Step 1 – Make all desired power, audio in, audio out,
configuration switch and I/O connections to the unit
and power up. Unit will initiate self test and default to
idle mode
Step 2 – Provide a maintained input signal between the Record
Input(Connector 2 terminal 1) and common(Connector
1 terminal 1), this will blink the Record LED.
