MACDONALD INDUSTRIES LIMITED
INSTALLATION INSTRUCTIONS
www.macdonaldindustries.co.nz
3
OPERATION:
Rotate base downward. Place infant on top of the changing surface.
Use restraint system as described below. After child has been changed,
remove restraint system and rotate base back up against the wall.
USE OF RESTRAINT SYSTEM:
Place child so restraint strap is located at abdomen. Rotate top of
buckle upward and insert strap in buckle. Pull strap through buckle until
snug against infant. Rotate top of buckle downward to lock the strap
into place. Slide red locking tab over top of buckle
(Fig. a)
. Reverse
steps to loosen strap.
MAINTENANCE AND CLEANING:
Check all hardware and components monthly or as required to ensure hardware is tight and there
are no missing or damaged components. Take unit out of service if any component is missing or
damaged and contact customer service to order replacement parts. Do not substitute parts.
For replacement parts, contact customer service at 09 624 1115.
Clean by using a damp cloth with mild soap or mild multi-purpose cleaner. Do not use any strong
chemical cleaners or cleaning agents that may be hazardous to children.
98.
4
TOP
VIEW
876
25.
4
Double stud
Double stud
Double stud
Double stud
FRONT
VIEW
552
Ro
ugh-in
Fig. b
720
A.F.F
876 Rough-in
492
Recess
Mounting
Holes
Recess Mounting Holes
Recess
Mounting
Holes
Fig. c
98.
4
TOP
VIEW
876
25.
4
Double stud
Double stud
Double stud
Double stud
FRONT
VIEW
552
Ro
ugh-in
Fig. b
720
A.F.F
876 Rough-in
492
Recess
Mounting
Holes
Recess Mounting Holes
Recess
Mounting
Holes
Fig. c
INSTALLATION - RECESSED
Position can be lowered to suit disabled
compliance.
Recommended Blocking
Wood double stud blocking is necessary. Contact
an architect and building official to make sure
the blocking is adequate and complies with
building codes
(Fig. b)
.
1. Slide changer into blocking area and mark
mounting hole location on blocking studs.
HINT:
This may require 2 additional people
to help hold changer in position while you are
marking the locations.
2. Shim changer for a snug fit.
3. Align holes in changer with marked holes and
secure using the appropriate fasteners
(Fig. c)
.
NOTE:
It is installers responsibility to provide
correct fasteners for other substrates.
4. Ensure all six (6) fasteners are tight.
