12 R2 Series Clinic Handout
Settings
1 . If the In Cab Remote Baffle is installed, the baffle is controlled inside the
windrower cab by buttons F5
(A)
(baffle up) and F6
(B)
(baffle down) .
No set-up is required on the display to activate controls .
2 . A pop up will appear on the display for 3 seconds indicating baffle
position from 0 – 10 .
In-Cab Electric Remote Baffle
Recommended Starting Settings with a DWA
Important:
Confirm that baffle can move freely through its range of motion and does not contact side deflectors .
1 . DWA adjusted low and close to the RH tire
2 . Tall crop feed plates installed
3 . Rear baffle deflector fins removed
4 . Forming shield top deflector fins removed . RH side deflector positioned straight back . LH side
deflector angled so that crop lands on the DWA .
5 . Tight conditioner roll gap (for crop conditions)
6 . Minimum disc speed of 2100 rpm
7 . Ensure right side of header is full (more than 10” of overlap will dramatically affect crop flow)
8 Header angle and baffle angle are key . Start with a mid position header tilt (4-7) . Ensure the crop is
dropping fully onto the DWA . Too steep of a header angle and the crop will hit the forming shield too
early, too shallow and the crop will not arc up towards the DWA . Use the rear baffle angle to adjust
how the crop is flowing into the forming shield .
9 . Enter crop at relatively high speed 8 km/h+ (5 mph+)
10 . Maintain consistent ground speed for consistent crop flow
Summary of Contents for R2 Series
Page 1: ...R2 Series Clinic Handout...