215333
182
Revision A
1014626
A
B
Figure 4.105: Accelerator Install
4.
Torque inside nut (A) to 58 Nm (43 lbf·ft).
5.
Torque outside nut (B) (closest to the blade) to 125 Nm
(92 lbf·ft).
6.
Repeat the installation procedure for the second
accelerator.
WARNING
Ensure the cutterbar is completely clear of foreign objects.
Foreign objects can be ejected with considerable force when
the machine is started and may result in serious injury or
machine damage.
7.
Remove the wooden block.
1010658
Figure 4.106: R1 Series Rotary Disc Pull-Type
8.
Close cutterbar doors. For instructions, refer to
Closing Cutterbar Doors, page 38
4.4.10
Rock Guards
The machine is equipped with rock guards at each cutting disc location. Rock guards prevent the cutterbar from digging
into the ground and protect the disc from coming in contact with stones and other debris. Periodically inspect rock guards
for damage and replace as necessary.
Inspecting Rock Guards
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, stop the engine, remove the key,
and engage the windrower lift cylinder safety props before going under the machine for any reason.
1.
Raise the header fully.
2.
Shut down the engine, and remove the key from the ignition.
3.
Engage lift cylinder lock-out valves. For instructions, refer to
.
