Subject to change without notice
Tips:
•
Sharp blades reduce horsepower
requirements.
•
Install cutterbar deflectors
(A)
when cutting tall, stemmy
crops.
•
Remove cutterbar deflectors
to
reduce debris buildup on the
cutterbar.
Rocky, ridged, or loose ground
45
kg (100
lb.) float setting
Smooth, level, or firm Ground
55
-
70
kg (125
-
150
lb.) float setting
1.
The adjust float springs, close lift cylinder valve
(A).
2.
Remove spring lock plate
(B) and lock plate hardware
(C).
3.
Turn adjuster bolt
(D) to adjust measurement
(E):
•
Turn bolt
(D) clockwise to increase the float.
•
Turn bolt
(D) counterclockwise to decrease the float.
4.
Install lock plate
(B) and hardware
(C).
Float Springs
800 PTO rpm
1000 PTO rpm
Light/Thin Crop
Heavy/Tough Crop
Disc Speed
Float Indicator
From the tractor
’
s
operator position, the float
indicator provides a visible
representation of the
header ground pressure.
When calibrated properly,
the float indicator pointer
will react to ground
pressure as follows:
•
Pointer centered on
number 2 (A):
header on level ground in cutting position, normal
ground pressure
•
Pointer above number 2
: header on ground, increased ground
pressure
•
Pointer below number 2:
header off the ground, decreased ground
pressure
1.
Adjust lower hitch arms (A) so dimension (B) between the bottom of the
carrier frame and the ground is 184
mm (7.25
in).
NOTE:
The cylinders must be lowered onto downstops (F).
2.
Adjust the length of top link (C) on the 3
-
point hitch until carrier frame
angle (D) is approximately 2° forward. Use bubble level (E), located on the
right side of the carrier frame to set the angle.
Carrier Frame Alignment
Cutterbar
Adjusting Side Deflectors:
1.
Loosen locking handle (A).
2.
Slide adjuster bar (B) along
adjuster plate (C) to the
desired deflector position
and engage bar
(B) into a
notch in the adjuster plate.
3.
Repeat adjustment on the
opposite side.
Side Deflectors
Windrow Formation
Adjusting Conditioner Baffle:
1.
Remove lynch pin (A).
2.
Pull conditioner baffle
adjustment lever (B) inboard
and position as follows:
•
Move the lever forward to
raise the baffle.
•
Move the lever backward to
lower the baffle.
3.
Release lever and engage with
notched bracket (C).
4.
Secure the lever with lynch pin.
Conditioner Roll Baffle
Float Indicator
