215676
335
Revision A
Inspecting and Cleaning Fresh Air Intake Filter Element
Once the filter element has been removed, it can be cleaned with compressed air and inspected for damage. Replace
damaged filter elements.
1025126
A
Figure 5.30: Fresh Air Filter Element
1.
Tap the sides of filter element (A) gently to loosen the
accumulated debris. Do
NOT
tap the element against a hard
surface.
2.
Using a dry element cleaner gun, clean the element with
compressed air.
IMPORTANT:
The air pressure used to clean the filter must
NOT
exceed
414 kPa (60 psi). Do
NOT
direct air against the outside of
the element, as dirt might be forced through the filter to
the inside.
3.
Hold the air nozzle next to the filter element
’
s inner surface
and move the nozzle up and down the pleats.
4.
Repeat Steps
to
as needed.
5.
Hold a bright light inside the element and check carefully
for holes. Discard any element that shows even a
small hole.
6.
Check the outer screen for dents.
7.
Check the filter gasket for cracks, tears, or other signs of
damage. If the gasket is damaged or is missing, replace the
element.
Installing Fresh Air Intake Filter
Once the filter has been cleaned, or if a new filter is to be installed, it can be placed onto the element tray and installed in
the windrower.
Refer to
8.2.4 Filter Part Numbers, page 478
for the appropriate part number.
1000127
A
B
Figure 5.31: Fresh Air Filter
1.
Clean tray (B) and the interior of the filter housing.
2.
Place filter (A) onto tray (B).
