MAINTENANCE AND SERVICING
169552 / 169554
184
Revision D
7.12 WHEELS AND TIRES
7.12.1 Drive Wheels
7.12.1.1 Tire Inflation
a.
Visually check daily that tires have not lost
pressure. Under-inflation of drive tires can cause
side wall cracks.
DANGER
To avoid severe personal injury or death
caused by machine runaway, shut off
engine, and remove key before performing
any of the following checks and/or
adjustments.
b.
Measure tire pressure annually with a gauge.
Maintain the pressure as follows:
1.
Determine tire size and type that is installed
on your machine.
2.
See Section
4.2 SPECIFICATIONS
to
determine recommended tire pressure.
3.
Adjust tire pressure as required.
DANGER
•
NEVER install a tube in a cracked wheel
rim.
•
NEVER weld a wheel rim.
•
Make sure all the air is removed from a
tire before removing the tire from the rim.
•
NEVER use force on an inflated or
partially inflated tire. Make sure the tire is
correctly seated before inflating to
operating pressure.
•
Do NOT remove, install or make repairs
to a tire on a rim unless you have the
proper equipment and experience to
perform the job. Take the tire and rim to a
qualified tire repair shop.
•
If the tire is not correctly located on the
rim, or if too full of air, the tire bead can
loosen on one side, causing air to leak at
high speed and with great force. An air
leak of this nature can thrust the tire in
any direction, endangering anyone in the
area.
•
Do NOT exceed maximum inflation
pressure as per label on tire.
•
Use a safety cage if available.
•
Do NOT stand over tire. Use a clip-on
chuck and extension hose.
7.12.1.2 Wheel Nut Torque
At first use, or when a wheel is removed, re-
torque drive wheel nut torque after one hour of
operation.
Continue with torquing procedure at one hour
intervals of operation until two consecutive
checks produce no movement of the nuts.
a.
Tighten nuts to 220 lbf·ft (300 N·m) using the
tightening sequence as shown above.
NOTE
To avoid damage to wheel rims, do
NOT
over-tighten wheel nuts.
b.
Repeat sequence three times.
1
5
3
7
8
2
4
6
•
Replaces Page 184 in M105 Op Manual
Summary of Contents for M105
