MacDon HC10, Setup, Operation, And Parts Manual

Page: 49 / 186

215593
39
Revision A
3.8 Assembling Forming Shield
The forming shield shapes and controls the distribution of conditioned crop.
1. Retrieve the following parts from MD #B4800:
•
Forming shield with baffle, struts, and hardware attached
Retrieve the following parts from the deflector package shipped with MD #B4798:
•
Forming shield deflectors with hardware attached
Retrieve the following parts from the finishing bag shipped with MD #B4798:
•
Deflector fin (left side)
•
Deflector fin (right side)
•
Four smaller deflector fins
Retrieve the following parts from the hardware bag shipped with MD #B4798:
•
Eight 3/8 x 3/4 in. carriage bolts
•
Eight 3/8 in. flange nuts
$
Figure 3.53: Forming Shield Cover
2. Lay forming shield (A) upside down ( side support flanges
facing up) on a flat surface.
$
%
Figure 3.54: Deflector Fins
3. Attach short fins (A) and long fins (B) to the shield using
two 3/8 x 3/4 in. carriage bolts and two 3/8 in. flange nuts
per fin:
•
Attach short fins (A) to bottom of shield as shown in
illustration using hardware provided.
•
Two long fins (B) are handed and should be installed
with bolts on outboard side of the fin. Bolts should be
installed with nuts against the fins.
NOTE:
Fins are only effective for windrows wider than 1778 mm
(70 in.) or if windrow shape is unsatisfactory. Store fins for
future use if not installed.
UNLOADING AND ASSEMBLY