MacDon D1X Series, Unloading And Assembly Instructions, Page: 63 / 108

214778
57
Revision A
5.5 Centering the Reel
Refer to the topic for header type:
•
5.5.1 Centering Double Reels, page 57
•
5.5.2 Centering Single Reel, page 58
5.5.1 Centering Double Reels
WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key before
adjusting machine.
1019035
A
Figure 5.13: Double Reel Measurement Locations
1. Measure clearances at locations (A) between reels and both
endsheets. The clearances should be the same if the reels
are centered. If the reels are not centered, proceed to
Step
2, page 57 .
1026077
B
C
B
A
Figure 5.14: Reel Center Support Arm
2. Loosen bolts (A) on each brace (B) located on both sides of
the reel center support arm (C).
3. Move the forward end of the reel center support arm (C)
laterally as required, to center both reels.
4. Tighten bolts (A) and torque to 382 Nm (282 lbf
∙
ft).
PERFORMING PREDELIVERY CHECKS