MacDon D1X Series, Unloading And Assembly Instructions, Page: 64 / 108

214778
58
Revision A
5.5.2 Centering Single Reel
WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key before
adjusting machine.
1001595
A
Figure 5.15: Single Reel Measurement Locations
1. Measure the clearance at locations (A) between the reel
and endsheets. The clearances should be the same if the
reel is centered.
•
If the reel is not centered, proceed to Step 2, page 58 .
•
If the reel is centered, proceed to 5.6 Adjusting Draper
Tension, page 59 .
1016444
A
B
C
Figure 5.16: Reel Support Arm
2. Loosen bolt (A) on the brace (B) at both ends of the reel.
3. Move the forward end of the reel support arm (C) laterally
as required, to center the reel.
4. Tighten bolt (A) and torque to 359 Nm (265 lbf
∙
ft). Repeat
at opposite side.
PERFORMING PREDELIVERY CHECKS