214923
6
Revision A
2.1
Removing Driveline
Refer to the correct topic below for your model:
•
•
2.1.1
Removing Driveline
–
FM100
WARNING
To avoid injury or death from unexpected start-up of machine, always stop engine and remove key from ignition before
leaving operator
’
s seat for any reason.
1.
Shut down the combine, and remove the key from the ignition.
1028268
B
C
C
A
D
Figure 2.2: Float Module End of Driveline
3.
Loosen two bolts (C), and remove driveline shield (B).
4.
Detach safety chain (A) (if equipped) from chain (D) on the
driveline shield. Do
NOT
disconnect chain (D).
5.
Pull the quick disconnect collar to release the driveline
yoke, and pull the driveline off the gearbox shaft.
1020759
A
B
C
Figure 2.3: Combine End of Driveline
6.
Pull driveline collar (A) away from power take-off (PTO)
support (B). Slide yoke (C) off support bracket (B), and
release collar (A).
