214923
11
Revision A
2.4
Installing Driveline
Refer to the correct topic below for your model:
•
•
2.4.1
Installing Driveline
–
FM100
WARNING
To avoid injury or death from unexpected start-up of machine, always stop engine and remove key from ignition before
leaving operator
’
s seat for any reason.
1028284
A
B
Figure 2.13: Driveline Halves
IMPORTANT:
If the combine output shaft splines match the float module
input shaft splines, ensure the driveline is installed with the
shorter guard (A) at the combine end and the longer
guard (B) at the float module gearbox end.
1023809
A
B
C
D
Figure 2.14: Combine End of Driveline
1.
Position the combine end of driveline (A) onto storage
support (B). Pull back collar (C) on the driveline and slide
the driveline onto the support until it locks in place. Release
collar (C).
2.
For drivelines equipped with safety chains, attach chain (D)
at the combine end to driveline storage support (B).
