215339
17
Revision A
1031513
A
B
C
D
D
Figure 3.23: Alignment Tool on Right Driven Drum
10. On the right side of the cutterbar, slide drive alignment
tool (A) over spindle shaft (B) on the cutterbar.
NOTE:
Tool may need to be rotated to clear the hub to insert it
inside the drum.
11. Attach right drive alignment adapter (C) (MD #307302) to
right drive hub using bolts (D) (MD #281605).
1031519
A
B
Figure 3.24: Alignment Tool on Right Driven Drum
12. Attach drive alignment tool (A) to right drive alignment
adapter (B) using four M12 bolts, and tighten until snug.
IMPORTANT:
If the alignment tool is not secured to the right drive
assembly using all four bolts, the drive hub will be
misaligned.
13. Use a pry bar to move the right side of the cutterbar fore or
aft until the alignment tool
’
s bottom tube slides freely over
the cutterbar driveshaft.
14. Repeat Steps
to
, and check that the
tube on the drive alignment tool can still slide up and down
freely on the left and right cutterbar driveshafts. If there is
binding, loosen the cutterbar mounting bolts and recheck
the cutterbar alignment.
1031526
A
B
C
D
E
F
G
Figure 3.25: Cutterbar Bolts
–
Bottom View, Left End
Shown, Right End is Opposite
15. On inboard support (B), apply high-strength threadlocker
(Loctite® 262 or equivalent) to bolt (E) and torque bolt to
725 Nm (535 lbf·ft).
NOTE:
Use a paint pen or grease pencil to mark all bolts with
a slash once they have been torqued.
16. Repeat Step
for bolt (F) and bolt (G).
17. On outboard support (A), torque bolt (C) to 170 Nm
(125 lbf·ft).
NOTE:
Use a paint pen or grease pencil to mark all bolts with
a slash once they have been torqued.
18. Repeat Step
for bolt (D).
19. Repeat Steps
to
on the opposite
side of the cutterbar.
