214079
7
Revision C
Chapter 3:
Installation Instructions
To install the Auger Drive kit, follow these procedures in order.
3.1
Removing Feed Auger
To remove the feed auger from the adapter, follow these steps:
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine, remove key, and
engage safety props before going under machine for any reason.
NOTE:
Unless otherwise stated, retain all parts for reinstallation.
1.
Detach the header from the combine. For instructions, refer to the header operator
’
s manual.
2.
Shut down the combine, and remove the key from the ignition.
1023056
C
A
A
E
D
F
B
G
B
Figure 3.1: Auger Drive
3.
Locate auger chain case on left end of feed auger.
4.
Remove the four bolts (A) securing the top cover to the left
side of the auger chain case.
5.
Remove and discard bolts (B) securing cover retainer
plate (F).
6.
Remove and discard cover retainer plate (F) and top
cover (C).
7.
Remove three bolts (D) securing the bottom cover.
8.
Remove drive cover retainer (G).
9.
Remove and discard bottom cover (E).
