MANUAL
DT-2100
62
ERROR LOG
Displays the error log number.
Displays the cause of the error, see below.
Error 01 is displayed with date and time according to the TV-channel
information.
Display how many secundes after the Reset-button is used or start
(power up) som felet uppstod.
Technical specifikations
FRONT END-DVB QPSK DEMODULATOR
Frequency range
920–2150MHz
Symbol rates
2 to 40MS/s
LNB power and control
13V/18V, 22kHz on/off
Input level
–60 to –30dBm
VIDEO OUTPUT
Frequency
0–5,0MHz 1V p-p
Group delay
±30ns
2T K factor
<1%
Diff. phase
<1deg.
Signal to noise ratio
>58dB
2 Video outputs
1 Vp-p,
BNC female 75
Ω
TELETEXT TRANSCODER PAL
Reinserted in PAL, VBI
CCIR system B
AUDIO OUTPUT
1 Balanced
600
Ω
audio pair (XLR)
1 Unbalanced
600
Ω
audio pair (RCA)
Frequency response
20Hz to 20kHz ±0,5dB
THD
>–65dB
GENERAL DATA
Alarm
Active high & low logic
outputs on rear panel
TS output
Parallel LVDS output
Input voltage
180 to 260 VAC 50/60Hz
Cooling fan
Built in
(Units may be stacked)
Width
19" rack
Height
1 rack unit (1HE)
Temperature
–10 to +45 Working
–20 to +70 Storage
002
:03
XXXXXXXX
002:
03
XXXXXXXX
002:03
00000000
Remark
: When the Cam is removed the receiver make a reset every 60
sec and the log file get entries until the CAM is connected.
Message _ _
01 = Power up – after manual or automatic reset and power up.
02 = QPSK loss – when the receiver lost the signal.
03 = QPSK lock – when the receiver find and lock the signal.
04 = Video stop – if the program card have no access or the video signal is lost.
00983-4 DT-2100 ENG-1.p65
2001-03-29, 11:20
62
