800.MACTOOLS
9
Fig. 2
A
Charging:
To charge the unit, connect the USB charging cable into
the charging port (A, Fig. 2) on the unit and then plug it in to an
appropriate USB port. An AC adaptor can also be used to charge the
unit via a standard electrical outlet.
Longest life and best performance can be obtained if the battery
pack is charged when the air temperature is between 18° and 24 °C.
DO NOT charge the battery pack in an air temperature below +4.5 °C,
or above +40.5 °C. This is important and will prevent serious
damage to the battery pack.
NOTE:
While the unit is charging, the LED Light will blink conti-
nuously indicating that the charging process has started. The
completion of charge will be indicated by the LED light remaining
ON continuously in a dimmed state. The battery pack is fully char-
ged and may be used at this time or left in the charger. NOTE: To
ensure maximum performance and life of lithium-ion battery packs,
charge the battery pack fully before fi rst use. The LED Light will fully
recharge in 4 hours or less.
CAUTION: Do not stare into LED light. Serious eye injury could result.
There are two LED lights located around the square drive. The LED lights are activated when the trigger switch
is depressed.
- The LED lights will turn off after being illuminated for 20 seconds.
NOTE:
The LED Lights are for lighting the immediate work surface and are not intended to be used as a fl ashlight.
ADAPTOR STATUS INDICATOR
Fig. 3
State of charge
charging
_ _ _ _
fully charged
________
SERVICE
•
Tool service must be performed by qualifi ed repair personnel, using only Mac Tools authorized, identical
replacement parts. Use only lubricants recommended by Mac Tools.
MAINTENANCE
Lubrication
Air tools require lubrication throughout the lifetime of the tools.
This power tool uses compressed air as a power source. The compressed air contains moisture that will rust the
components inside of the tools, therefore lubrication is required daily. Failure to lubricate the air tool properly
will dramatically shorten the life of the tool and will void the warranty
CAUTION:
This air tool requires lubrication
BEFORE
initial use, also before and after each additional use.
To lubricate the air tool manually:
1. Disconnect the tool from the air supply source, place the air inlet face up.
2. Depress the trigger and place about 5 to 10 drops (0.25 to 0.5 ml) of air tool oil into the air inlet.
NOTE: Use SAE #10 weight oil if air tool oil is not available.
