Instruction Manual
MAN-001
36
www.macmedical.com
7.
Use a flathead screwdriver to remove the 2 smaller satin plugs (circled in red) from the top and bottom of
the opposite side of the cabinet. These are the new hinge positions (Fig. 54).
8. Re-insert the 2 satin plugs (that were removed from the new hinge positions) in the old hinge positions.
9. Re-install the male halves of the door hinges in these positions. Do not tighten the screws at this point (Fig.
55).
10.
Attach the glass door to the unit by fitting the two halves of the glass door hinges together, Before securing
the door to its hinges, square the door by checking the door’s alignment with the header assembly box.
Then tighten the hinge screws (Fig. 56).
Fig. 55: Install Male Hinge Halves in New Position
Fig. 56: Check Alignment - Square Door
Fig. 54: Remove Satin Plugs from New Hinge Position
Summary of Contents for D Series
Page 41: ...Instruction Manual MAN 001 41 www macmedical com Wiring Diagram Single Chamber Warmers ...
Page 42: ...Instruction Manual MAN 001 42 www macmedical com Wiring Diagram Dual Chamber Warmers ...
Page 43: ...Instruction Manual MAN 001 43 www macmedical com Wiring Diagram Triple Chamber Warmers ...
