Mac allister MLMP300H40, Manual

Page: 17 / 24

32 33
MLMP300H40 MLMP300H40
In
more
detail
. . .
In
more
detail
. . .
Stopping
Release the brake clutch (2) to stop the engine and blade (24) (Fig. 25).
25
2
Mowing
NOTE: Avoid mowing when the grass is wet from rain or dew. Wet grass may
form clumps which interfere with the mulching action and reduce runtime.
The best time to mow grass is late afternoon when the grass is dry and the
newly cut area will not be exposed to direct sunlight.
Preparing the product according to required application
Function Grass catcher (20) Mulching insert (26)
Grass collection installed removed
Mulching removed installed
General tips
1. Make sure that the lawn is clear of stones, sticks, wires or other objects that could
damage the product or its engine.
2. Do not cut wet grass because it tends to stick to the underbody of the product,
preventing the proper discharge of grass clippings, and it could also cause you
to slip and fall.
3. Never cut off more than one-third of the total length
of the grass for a healthy lawn. In the autumn, lawns
should only be cut as long as there is growth.
4. Slowly push the product forward.
5. Mow in slightly overlapping rows. The most effective
pattern for mowing lawns is straight lines along one of
the sides. This keeps the rows even and ensures that
all the lawn is cut without missing any spots (Fig. 26).
26
WARNING! The starting position should be as described in the instruction
manual. Fig. A
start the engine behind the handle (1). Do not start the engine while standing
on the side of the product as shown on Fig.
B .
A
B
1
Warm start
1. Pull the brake clutch (2) towards the handle (1) and hold it in position (Fig. 22).
2. Stand behind the handle (1).
3. Place the recoil starter handle (23) onto the hook (22) located on the right-hand
side of the upper handle bar (3) (Fig. 24).
4. Pull the recoil starter handle (23) lightly until you feel resistance then pull it rapidly.
Do it repeatedly until the engine starts (Fig. 23).
5. During operation rest the recoil starter handle (23) onto the hook (22) (Fig. 24).
NOTE:
by too much fuel injected into the combustion chamber and can prevent the
1. Remove the spark plug located under the spark plug connector (13) and
dry it - see the separate operator’s manual of the BRIGGS&STRATTON
engine (28).
2. Wait for 10
any spilt fuel and move the product at least 3 metres away before starting
3. Start the engine.
Operation Operation