EN
17
In
more
detail...
MHT60060
by MacAllister
Intended use
This electric hedge trimmer MHT60060 is designated with a rated power input
of 600 Watts.
The product is intended for cutting and trimming of hedges, bushes and shrubs
in domestic gardens. The maximum cutting capacity must be observed. Do not
cut branches exceeding the stated maximum capacity.
The use of this product in case of rain or humid environment is prohibited.
For safety reasons it is essential to read the entire instruction manual before
first operation and to observe all the instructions therein.
This product is intended for private domestic use only, not for any commercial
trade use. It must not be used for any purposes other than those described.
Product functions
Sweep adjustment
1. Switch the product off and disconnect the product from the power supply.
2. Place the hedge trimmer on a sturdy flat surface.
3. Loosen the locking knobs (1a) anti-clockwise from the nuts of the cutting
device (blade) (13) by hand, but don’t remove them (Fig. 6, step 1).
4. Slide the sweeper (1) along two slots (1b) to a desired position
(Fig. 6, step 2).
5. Secure the connections with the locking knobs (1a) clockwise by hand
(Fig. 6, step 3).
NOTE:
The orientation of sweeper (1) can be changed according
to the intended use, please follow steps described in the chapter of
“Setup->Sweeper” for details.
WARNING!
Wear safety gloves when working on the cutting device
(blade) (13) and close to it! Never use your bare hands!
1
1a
1b
1a
1b
2.
1.
1.
3.
3.
Fig. 6
Summary of Contents for MHT60060
Page 32: ......