EN
25
In
more
detail...
MHT60060
by MacAllister
Problem
Possible cause
Solution
1. Product does
not start
1.1. Not connected to
power supply
1.2. Power cord or plug is
defective
1.3. Other electrical defect
to the product
1.1. Connect to power
supply
1.2. Check by a specialist
electrician
1.3. Check by a specialist
electrician
2. Product does
not reach full
power
2.1. Extension cord not
suitable for operation
with this product
2.2. Power source
(e.g. generator) has
too low voltage
2.3. Air vents are blocked
2.1. Use a proper
extension cord
2.2. Connect to another
power source
2.3. Clean the air vents
3. Unsatisfactory
result
3.1. Blade is worn /
damaged
3.2. Thickness of branches
exceeds capacity
3.1. Replace with a new one
3.2. Only cut branches
complying with the capacity
4. Excessive
vibration or
noise
4.1. Blade is dull /
damaged
4.2. Bolts/nuts are loose
4.1. Replace with a new one
4.2. Tighten bolts/nuts
Troubleshooting
Troubleshooting
Suspected malfunctions are often due to causes that the users can fix
themselves.Therefore check the product using this section. In most cases the
problem can be solved quickly.
WARNING!
Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be
performed by an authorised service centre or a similarly qualified
specialist if you cannot solve the problem yourself!
Summary of Contents for MHT60060
Page 32: ......
