EN
28
In
more
detail...
MGT45028
by MacAllister
Care and maintenance
The golden rules for care
WARNING!
Always switch the product off, disconnect the product
from the power supply and let the product cool down before
performing inspection, maintenance and cleaning work!
1. Keep the product clean. Remove debris from it after each use and before
storage.
2. Regular and proper cleaning will help ensure safe use and prolong the life of
the product.
3. Inspect the product before each use for worn and damaged parts. Do not
operate it if you find broken and worn parts.
WARNING!
Only perform repairs and maintenance work according to
these instructions! All further works must be performed by a qualified
specialist!
General Cleaning
1. Clean the product with a damp cloth and pH-neutral soap. Use a brush for
areas that are hard to reach.
2. In particular clean the air vents after every use with a cloth and brush.
3. Remove stubborn dust with high pressure air (max. 3 bar).
NOTE:
The trimming line will extend about 3-5 mm with each stop
and start until the line reach the length of the knife. Avoid stop and
start frequently as the trimming line may auto-feed unintentionally and
causes waste a lot of line.
4. Check for worn or damaged parts. Replace worn parts as necessary or
contact an authorised service centre for repair before using the product
again. Check for worn or damaged parts. Replace worn parts as necessary or
contact an authorised service centre for repair before using the product again.
Guard
1. Keep the guard (11) clean and free of debris. Remove trimmings.
2. Replace the guard (11) with one of the same type when it is worn or shows
damage.
Summary of Contents for MGT45028
Page 40: ......