Mac Afric THEATG-002, User Manual

Page: 6 / 11

6
accessories, or storing power tools. Such preventive safety measures reduce the risk of starting
the power tool accidentally.

Store idle power tool out of the reach children and do not allow persons unfamiliar with the
power tool of these instructions to operate the power tool. Power tools are dangerous in the
hands of untrained users.

Maintain power tools. Check for misalignment or sticking of moving parts, breakage of parts
and other condition that may affect the power tool
’s operation. If damaged, have the power tool
repaired before use. Many accidents are caused by poorly maintained power tools.

Keep cutting tools sharp and clean. Properly maintained cutting tools with cutting edges are
less likely to stick and are easier to control.

Use the power tool, accessories and tool bits etc., in accordance with these instructions and in
the manner intended for the particular type of power tool, taking into account the working
conditions and the work to be performed. Use of the power tool for operations different from
intended could lead to a hazardous situation.
4.5 Service

Have your power tool serviced by qualified repair person using only identical replacement parts.
This will ensure that the safety of the power tool is maintained.
5 ADDITIONAL SAFETY INSTRUCTIONS FOR HEAT GUNS

Do not place your hand over the air vents or block the vents in any way.

The nozzle and accessories of this tool become extremely hot during use. Let these parts cool
down before touching.

Always switch the tool off before putting it down.

Do not leave the tool unattended while it is switched on.

A fire may arise if the appliance is not used with care.

Heat may be conducted to combustible materials that are out of sight. Do not use in a damp
atmosphere, where flammable gases may be present or near combustible materials.

Allow the tool to cool fully before storing.

Ensure adequate ventilation as toxic fumes may be produced.

Do not use as a hairdryer.

Do not obstruct either the air intake or nozzle outlet, as this may cause excessive heat build up
resulting in damage to the tool.

Do not direct the hot air blast at other people.

Do not touch the metal nozzle as it becomes very hot during use and remains hot for up to 30
minutes after use.

Do not place the nozzle against anything while using or immediately after use.

Do not poke anything down the nozzle as it could give you an electric shock. Do not look down
the nozzle while the unit is working because of the high temperature being produced.

Do not allow paint to adhere to the nozzle or scraper as it could ignite after some time.
6 REMOVING PAINT

Do not use this tool to remove paint containing lead. The peelings, residue and vapors of paint
may contain lead, which is poisonous. Any pre-1960 building may have been painted in the past
with paint containing lead and covered with additional layers of paint.
Once deposited on surfaces, hand to mouth contact can result in the ingestion of lead.
Exposure even to low levels of lead can cause irreversible damage to the brain and nervous
system. Young and unborn children are particularly vulnerable.