16
1-888-818-2814 • [email protected]
STEPS:
11
. Once the unit is sitting
on top of the roof, take
the wire harness and
drill a hole in the
selected location to
pass it thru the roof,
using a Cable Gland,
well-sealed with the
same sealant used for
the gasket to prevent
water leaks.
12.
From inside the vehicle,
you will have the unit
upside down and
ready to tighten the
Fixing screws on the
nuts using the locating
plates provided.
If necessary,adjust the
plates to distribute the
stress on the roof
surface
Don’t exceed more
than 15Nm torque.
CUSTOMIZED INSTALLATION INSTRUCTIONS:
CONT'D
Summary of Contents for RVSC 12000 BTU DC 12V
Page 2: ......