MAAX 2007 Elite spas, Owner'S Manual

Page: 23 / 48

23
You should now see the “ PROGRAM ”,
“ FILTER 1 ”, and “ START TIME ” icons on the LCD
display window. The hour digit(s) will be flashing on
the LCD window. Press the “
Warm ” or “ Cool ”
button to advance the hours up or down to choose the
Filter 1 start hour. Enter the hour by pressing the
“
Mode/Prog ” button. The minute digits will now be
flashing on the LCD window. Press the “ Warm” or
“Cool ” button to advance the minutes up or down, in 5
minute increments, to choose the Filter 1 start time.
Enter the minutes by pressing the “
Mode/Prog ”
button.
You should now see the “ PROGRAM ”,
“ FILTER 1 ”, and “ END TIME ” icons on the LCD
display window. Adjust the hours and minutes for the
end time of the first filter cycle as described above.
After pressing the “ Mode/Prog ” button to
enter the end time of the first filter cycle, you should
now see the “
PROGRAM ”, “ FILTER 2 ”, and
“ START TIME ” icons on the LCD display window.
Adjust the hours and minutes for the start time of the
second filter cycle as described above.
After pressing the “ Mode/Prog ” button to
enter the start time of the second filter cycle, you
should now see the “
PROGRAM ”, “ FILTER 2 ”, and
“ END TIME ” icons on the LCD display window.
Adjust the hours and minutes for the start time of the
second filter cycle as described above.
After pressing the “ Mode/Prog ” button to
enter the end time of the second filter cycle, the new
filtration times will be saved into the system and the
LCD window will revert back to display the current
water temperature.
Pressing the “ Time ” button at any time during
the above programming sequence will save the values
entered up to that point and exit the programming
sequence.
To set the spa for continuous filtration, set the
start and end times of the first filter cycle to the exact
same time.
Clean Up Cycle
After periods of heavy use, turn the jets on to Low
Whirlpool for a four-hour clean up cycle.
Inversion Feature
The 460 Series Control includes an Inversion feature
that makes it easy to read the LCD from inside or
outside the spa. To invert the LCD display, touch the
WARM or COOL button, followed by the “ Blower ”
button. Repeat the sequence to reverse the inversion
process.
Auxiliary Panel
Select models are equipped with an auxiliary
control panel which allows you to operate all three
pumps and the internal light without leaving the
comfort of the Full-Body Massage Seat ™.
JETS 1
Touch the JETS 1 pad to activate the primary
filtration pump. The sequence of the jet action is:
1 touch = Low whirlpool jets
2 touches = High whirlpool jets
3 touches = Off
JETS 2
Touch the
JETS 2
pad to activate the second
therapy pump. The sequence of jet action is:
1 touch = Low therapy jets
2 touches = Off
AIR
Touch the AIR pad to activate the blower.
The sequence of the blower is:
1 touch = On
2 touches = Off
LIGHT
Touch the LIGHT pad to activate the light.
The sequence of the light is:
1 touch = On
2 touches = Off