33
33
PowerPool
™
Problem
Noisy pump
and motor
No water flow
from jets
Water leakage
from under
PowerPool™
No air flow
from jets
Motor will
not operate
Black powder
film around
water line
PowerPool™ will
not shut off
Usual Cause
- Clogged or blocked suction or skimmer
- Low water level
- Damaged or worn motor bearings
- Pump not primed
- Adjustable jets turned off
- House circuit breaker tripped,
no power to system
- Faulty pump or motor
- Pump surges
- Slice valves closed
- Check unions & drain hoses
- Check for water seepage around jets
or at glued fitting
- Air control not open
- Jet nozzle not seated properly
- Jet nozzle missing
- House circuit breaker tripped or in
OFF position
- Improper or defective wiring or
electrical supply
- Pump thermal overload switch tripped
- Wearing in of turbo/blower brushes
- PowerPool™ is in heating cycle
- PowerPool™ is in filter cycle
- PowerPool™ is in standard mode
Solution
- Clean suction grate and
skimmer basket
- Add water to normal water level
- Contact dealer
- See Priming section, pg. 15
- Turn on jets
- Reset circuit breaker at
house panel
- Contact dealer
- Check water level
- Open slice valves; ensure valve
safety clips are attached
- Close or tighten as necessary
- Contact dealer
- Open control
- Check jet nozzles
- Inspect jets and replace
as necessary
- Reset house circuit breaker in
panel box
- Contact dealer
- Auto reset after pump motor has
cooled. Contact dealer if pump
continues to cycle
- Will disappear after use
- Check ‘Set Temperature’ in
standard mode
- Normal. No need to change
- Check mode setting
